Welcome to the 'How To' section
![]()
How to roll a spliff or 'skin up'
Of course there are different styles and techniques to rolling but at the end of the day a spliff is a spliff and it gets you high, so don't bitch!

This method is a little different to the one i use but if i know you then i will be pleased to teach you personally!is method is a little different to the one i use but if i know you then i will be pleased to teach you personally!
The easiest way to 'skin up' is to use RIZLA king skins, it is alot easier than making a 'deck' (shown above).
OR

KULU Rice paper king skins
or even

These are good as they contain papers and roaches or 'tips'.
How to roll a spliff;
You will need:
Papers
Tobacco
Hash
Roaches
Lighter
Method
Step 1: Take a King Skin from the pack and place it on a flat surface, ensurering that the sticky line is furthest away from you.
Step 2: Crumble your tobacco into the skin making sure that it is evenly distributed along the crease of the paper.
Step 3: Burn and sprinkle in your hash, ensurering that you put and even layer of hash over the tobacco.
Step 4: (This is the difficult bit) Pick up the skin and hold it so that the tobacco is held by the paper between you first and second finger and your thumb (like you were feeling a soft material), gently and slowly move you fingers along the paper making sure that all the tobacco has had an even 'roll'. When you see/feel that the tobacco ressembles a cylinder. When this is done roll the none sticky side of the paper down and tuck it between the tobacco and the sticky side with your thumb and first finger. Slowly roll the cylinder away from you until all that is showing is the sticky bit, lick the sticky bit and roll it down. When you have done this you will have what looks like a ciggarette but a bit longer!
Step 5: Poke down the end that will be the 'cherry' (the bit you will light) using a match or a Clipper flint, once you have poked this bit down there are a variety of seals that you can use, the most common being the 'Butterfly' or the 'Twist'. Now that you have sealed the cherry you can add the 'roach' (the cardboard filter). Tear a small rectangle off the flap of your rizla box, approx. 1cm thick and 5 cms long, (this depends on how much space is avalible for the roach!)Wrap the card around a match so you have a little coil, slide this coil in to the roach end of you spliff and push it down. Bite off the twist or butterfly and spit it out, put the roach end in your mouth, light up and enjoy...
As with everything, PRACTISE MAKES PERFECT !
How to roll a 'Cone';
Cones, a real good way to repel your sanity.
You will need:
Papers
Tobacco
Hash
Roaches
Lighter
Method
Step 1: Take a King Skin from the pack and place it on a flat surface, ensurering that the sticky line is furthest away from you.
Step 2: Crumble your tobacco into the skin making sure that there is more tobacco in one end than in the other. This will form you 'cone' shape.
Step 3: Burn and sprinkle in your hash, ensurering that you put and even layer of hash over the tobacco.
Step 4: (This is the difficult bit) Pick up the skin and hold it so that the tobacco is held by the paper between you first and second finger and your thumb (like you were feeling a soft material), gently and slowly move you fingers along the paper making sure you put a little more pressureon the thinner end. When you see/feel that the tobacco ressembles a cone roll the none sticky side of the paper down and tuck it between the tobacco and the sticky side with your thumb and first finger. Slowly roll the cylinder away from you until all that is showing is the sticky bit, lick the sticky bit and roll it down. When you have done this you will have what looks like a ciggarette but a bit longer!
Step 5: Poke down the end that will be the 'cherry' (the bit you will light) using a match or a Clipper flint, once you have poked this bit down twist the end. Now that you have sealed the cherry you can add the 'roach' (the cardboard filter). Tear a small rectangle off the flap of your rizla box, approx. 1cm in width and 5 cms long, (this depends on how much space is avalible for the roach!)Wrap the card around a match so you have a little coil, slide this coil in to the roach end of you spliff and push it down. (it will unravel inside the spliff). Bite off the twist or butterfly and spit it out, put the roach end in your mouth, and light it up!
(I have found that with some experimentation that a spliff is just as good or even better without a roach, as the roach DOES filter some of the toxins out of the spliff), smoking a spliff without a roach is how Rastas smoke spliffs, so that must tell you something?
How to make a 'Tulip';
You will need:
Papers
Tobacco
Hash and Skunk
Roaches
Lighter
cotton
Pateince
Method
Step 1: Roll a normal spliff (technique above) but don't twist the cherry.
Step 2: Take 2 king skins and make them into a square.
Step 3: Fold the square into a cone shape (by folding the square into a triangle and folding the triangle in half once opening it out to make a cone). And fill it with a mix of you favorite skunk (it can be filled with a mix of tobacco and resign)
Step 4: Push the spliff you rolled earlier into the open end of the cone.
Step 5: Use the sticky bit off a rizla to fix the cone to the spliff. (I have found that using cotton works much better) Then you should end up with something like this...

How to make a Shotty;
The shotty is a damn fine way of turning your reality into custard! Also known as the 'Jill Dando pipe' because it blows your f**king head off!
You will need:
A plastic cola bottle, about 1 litre.
Some cigarettes.
About 7cm of metal pipe,(copper is best) a cigarette should fit snugly inside.
A sharp blade.
Some water.
Some hash.
Method:
Step 1: First you need to make a hole in the bottle for the pipie to fit in. You can do this with a knife blade, but i have found that using a lit cigarette works best to burn a cigarette sized hole.
Step 2: Push the pipe down through the hole, it should be tight. If it is not tight then wrap some sellotape around the pipe to secure it, secure the pipe to to bottle leaving about 1cm sticking out of the bottle. To keep the pipe at an angle you can wrap sellotape around the bottle and pipe.
Step 3: Fill the bottle with water, ensuring that the water level doesn't come ANYWHERE near the hole, even when the bottle is tilted(if this happens you, or whoever is taking hits will get a wet crotch).
Step 4: Now to pack the pipe. Take a fresh cigarette and push the lightable end about 2mm into the pipe and use your blade to cut off the reat of the cigarette, Burn and finley sprinkle some hash onto a saucer or a mix tray (to make a mix tray simply cut a cola can in half lengh ways) and dip the end with the cigarette in into the hash ensuring that it has a good coating of hash.
Step 5: Put your mouth over the end of the bottle (the drinking end!) and hold a flame over the showing open end of the pipe, suck SLOWLY and you will see the bottle gradualy fill with smoke after this you will see the cigarette slowley moving down the pipe, now suck HARD and the cigarette will shoot down the pipe into the water creating an air release thus shooting the smoke into you lungs at 90mph!
enjoy!
How to make a Shabang;
The Shabang is the easiest way of getting yourself wasted...Fast.
You will need:
A palstic cola bottle any size but no bigger than a 2 litre.
Spliff(s)
Lungs!
hash
Method
Step 1: Take the plastic bottle and burn a hole near the bottom of it with a lit cigarette.
Step 2: Burn one hole near the neck of the bottle, and another towards the middle, to make 'shot holes'.
Step 3: Roll a spliff.
Step 4: Put the spliff in the first hole you made making sure that it fits tightly. If it doesn't fit tightly make the hole smaller using tape or bigger using a lit cigarette.
Step 5: Put your lips arount the neck of the bottle and your fingers over the shot holes, suck hardish until the bottle fills with smoke. Now suck HARD and release your fingers from the shot holes, exhale and pull another.